- Why did GM stop making the 3800?
- How can I get more power out of my 3.8 v6?
- Is the 3.8 v6 a good engine?
- Is the 3800 engine good?
- What size engine is a 3800?
- How much horsepower does a 3800 v6 have?
- Can v6 beat v8?
- Can you put a supercharger on a stock 3800?
- Is the 3800 Series 2 a good engine?
- When did GM stop making the 3800?
- How much horsepower does a 3800 Series 2 have?
- What is the difference between a 3800 Series I II III?
- What cars have 3.8 supercharged?
- How much oil does a 3800 supercharger take?
Why did GM stop making the 3800?
The 3.8 was discontinued in 2009.
The 3.6 engine has had timing chain problems and the gas mileage is less than the 3.8..
How can I get more power out of my 3.8 v6?
How to Get More Horsepower From a 3.8 V6Increase the amount of air flowing into the engine. Air mixes with fuel in each engine cylinder to produce combustion, which in turn increases horsepower. … Increase the amount of fuel flowing into the engine. … Increase the amount of air flowing out of the engine.
Is the 3.8 v6 a good engine?
The 3.8 liter V6 was a conservatively designed, wider-bore, longer-stroke version of the then-new 3.3-liter V6. It was a good, solid engine from the start – not the highest performer or the lowest, but relatively quiet, driveable, and reliable….Premium Member.Category3.8 LiterFuel Regular (US: 87 octane)2 more rows•Nov 16, 2020
Is the 3800 engine good?
The 3800 is a reliable engine. I’ve seen quite a few over 200,000 miles. I’ve seen a lot over 100,000 miles with no problems. The two Camaros I’ve owned with the 3.8L were both in the 80,000 mile zone.
What size engine is a 3800?
The Buick V6, popularly referred to as the 3800 in its later incarnations, originally 198 cu in (3.2 L) and initially marketed as Fireball at its introduction in 1962, was a large V6 engine used by General Motors. The block is made of cast iron and all use two-valve-per-cylinder iron heads, actuated by pushrods.
How much horsepower does a 3800 v6 have?
The supercharged 3800 Series III, found in the Grand Prix GT or GTP (depending on model year), unleashed 260 horsepower. The 3800 and 3800 SC Supercharged engines offered 230 foot-pounds of torque at 4,000 RPM and 380 foot-pounds of torque at 5,200 RPM, respectively.
Can v6 beat v8?
A turbo V6 is likely to beat a non-turbo V8, unless there’s a MUCH bigger V8 than V6 (Mazda did a V6 of 1.8 liter some time ago, which was at the time the smallest V6 available – even with a turbo, that would NOT beat a 5.7 liter V8). … But given the same model of car, the V8 is likely to win over a non-turbo V6.
Can you put a supercharger on a stock 3800?
One of the most common questions in the 3800 market is “Can I bolt a GTP supercharger onto my GT (L36) engine. The short answer is no. The only things the non supercharged and supercharged 3800’s have in common are the block and crank.
Is the 3800 Series 2 a good engine?
3.8 engines have a pretty good reputation. … It has the 3800 series II engine. I put 1,000,000,000 miles in 6 years, now it has 1,331,560,423 the only things I’ve changed on it is the oil, the transmission fluid, the brake fluid radiator flush. It still runs great.
When did GM stop making the 3800?
19671988-2003: The 3800 becomes GM’s workhorse engine. The engine grew to 225 cubic inches in 1964. Production stopped in 1967, and GM sold engine and production tooling to the Kaiser-Jeep Corp., the company that owned the Jeep brand.
How much horsepower does a 3800 Series 2 have?
Both engines share the same engine blocks, but compression is reduced from 9.4:1 in the L36 to 8.5:1 for the L67. Power is up to 240 hp (180 kW) and 280 ft lbf (380 N m) of torque. Final drive ratios are reduced in most applications, for better fuel economy and more use of the engine’s torque in the low range.
What is the difference between a 3800 Series I II III?
The biggest difference between the motors is the Series III has stronger connecting rods, an aluminum upper plenum, which eliminated the leak point of the Series II, and it had a return-less fuel system setup.
What cars have 3.8 supercharged?
That said, you can find supercharged 3800 engines in the 1996-2005 Buick Park Avenue Ultra, the 1997½-2004 Buick Regal GS, and the 1996-1999 Buick Riviera, as well as various models from Pontiac, Chevrolet, and other makes within the GM family.
How much oil does a 3800 supercharger take?
This is a relatively simple process, but you do need 8 oz of the special supercharger oil, a 3/16″ Allen wrench, the pump mechanism from a pump spray bottle, and a container to catch the oil.